Satin Black PerfMesh pool fence beside a pool

How to Install a DIY Pool Fence, Step by Step

The short answer: measure your fence line, price and order the kit online, set your posts or spigots, measure between them before you cut anything, fit the panels and gate, then test that the gate closes and latches by itself.

1. Measure and plan

Break the fence line into straight sections and measure each one in millimetres. Mark where the gate goes and note any slopes. Our measuring guide walks you through it.

2. Price and order your kit

Pick your fence, enter your lengths and the calculator counts every panel, post, spigot, hinge and latch for you. Or send us a top view plan with measurements and we'll work everything out for you. Pick up free from our Canning Vale Warehouse, or have it delivered. Free Perth metro delivery on orders over $3,000.

3. Check what's under the fence line

  • Concrete or a slab: base-plate posts or spigots bolt straight down. Glass spigots can also be core drilled.
  • Soil or lawn: posts set into concrete footings.
  • Timber decking: fixings must reach a bearer or joist.

Concrete, core drilling and tool hire are not part of the kit.

4. Set your posts or spigots first

Start at a corner or a wall and work along the line. Keep every post plumb and in a straight line, and keep the tops level. Let footings set before you hang anything on them.

5. Measure between the posts, then cut

Set your posts first and measure between them before you cut anything. Aluminium panels can be cut down to suit an odd length. Use full-size panels wherever you can and put any cut panels at the ends of each run. PerfMesh cut panels need a Cut Panel Conversion Kit to frame the cut end.

Frameless Glass pool fence on spigots across paving and lawn
Frameless Glass pool fence on spigots across paving and lawn

6. Fit the panels

Fix each panel to the posts with its brackets and screws, or clamp glass into the spigots. Keep the gap under every panel at 100mm or less, and the top of the fence at least 1200mm above the ground on the outside.

7. Hang the gate

The gate must open outwards, away from the pool. Fit the self-closing hinges and the latch so the latch release sits at least 1500mm above the ground on the outside. Our self-closing hinges and glass pool gate guide cover the options.

8. Test the gate and check the clear zone

  1. Open the gate a few centimetres and let go. It should close and latch.
  2. Open it all the way and let go. Same result.
  3. Walk the outside of the fence. Keep the 900mm zone clear of anything a child could climb: pot plants, bins, BBQs, pool pumps and air-conditioning units.

Our pool fence height guide has all the numbers, and our WA pool fence rules guide has the full detail. Your local council inspects pool barriers, and the council inspector has the final say.

Rather we install it?

We also supply and install. See installation to book a site inspection.

Common questions

Can I install my own pool fence in WA?

Yes. Plenty of Perth home owners install their own pool fence. It must meet the WA rules, and your local council inspects pool barriers, and the council inspector has the final say.

What is the easiest pool fence to install yourself?

Aluminium Flat Top is usually the easiest, because the panels are light and fix to posts with brackets. Frameless Glass is heavier and needs care with spigots and levels.

How do I order a DIY pool fence kit?

Pick your fence, enter your lengths and the calculator counts every panel, post, spigot, hinge and latch for you. Or send us a top view plan with measurements and we'll work everything out for you.

Back to blog