Frameless Glass Pool Fencing Calculator

How to Measure Your Pool Area for Frameless Glass Fencing

1. Sketch Your Pool Area: Draw a rough layout showing each straight section of where the fence will go. Measure along the centre line of where the fence will sit—not the edge of your deck or slab. Start your measurement 100mm in from the slab or deck edge. This accounts for where the glass panels will sit on spigots.

2. Count Your Sections: A section is one straight line of fencing. Use a tape measure to get the length of each section (in millimetres). Write down each length on your sketch. Start a new section at each corner, curve, or change in ground height.

3. Mark Gate Locations: Decide where your gate(s) will go and mark them clearly on your sketch.

4. Mark Raked Panels: Input a raked panel if your fence line comes to a step up ie. a limestone wall or decking. A raked panel will step up the top of the fence to keep it pool compliant. The step up will mark the end of the section measurement. Rake panels cannot be a hinge for a gate, but they can be the latch side.

5. Gap Checkpoint: Check if you need gaps at the ends of each side — for example, if Side 1 and Side 2 connect directly (and so on), as shown in the diagram.*

6. Need Help? If you would prefer you can email us your measurements and we will give you exact pricing and work out what materials you need.